Tile and material guide
Tile Glossary
Every term this site uses, in plain English, with pointers to the pages that go deeper.
The Vocabulary Used Across This Site
This glossary defines the vocabulary our product tables and craft pages actually use, nothing imported for volume. Where a term has a whole page behind it, the definition stays short and points there.
Finishes and Surfaces
- MAT (matte)
- an unpolished, light-absorbing surface; forgiving of smudges and substrate honesty alike.
- POL (polished or gloss)
- a reflective surface that carries light and shows what matt hides.
- LAP (Lappato)
- semi-polished: partial gloss over texture, between matt and polished.
- STR (structured)
- a relief or textured face, often mixing matt and gloss in one surface.
- Satin
- a soft semi-gloss between matt and polished, without Lappato’s texture.
- Through-body
- porcelain colored through its full thickness rather than surface-glazed, so a chipped edge shows tile, not scar.
- Glazed
- a fired surface layer carrying the color and pattern over the tile body.
Edges and Formats
- Rectified
- mechanically cut to a precise square edge after firing, enabling narrow joints; the deep story has its own article.
- Field tile
- the main-surface tile, as opposed to decor pieces and trim.
- Plank
- a long, narrow format laid like boards, typically wood-look.
- Mosaic
- small formats on sheets, the format that follows slopes and turns corners.
- Decor and strips
- the accent pieces designed into a collection: bands, relief strips, and feature panels.
- Large format
- tile above roughly two feet in one dimension, where flatness becomes the project.
Ratings and Data
- DIN 51130 (R9 to R13)
- the European boot-and-oil ramp slip test; higher R means more grip. The full explainer has its own page.
- DIN 51097 (A, B, C)
- the barefoot wet-ramp classes for pool and shower zones.
- DCOF
- the American wet-friction standard; measured differently than DIN and not convertible to it.
- PEI / abrasion class
- glaze wear rating for floors, Class III and IV in our catalog; unglazed through-body tile is not PEI rated.
- Water absorption class
- the body-density classification behind the word porcelain, printed where the manufacturer’s declaration supplies it.
- Frost resistant
- rated to survive freeze-thaw, the prerequisite for outdoor use.
- Declaration of performance
- the manufacturer’s own certified spec document, the source our tables prefer.
Installation Words
- Substrate
- what the tile is installed onto; its flatness and soundness decide the job.
- Lippage
- one tile edge sitting proud of its neighbor, the failure you feel underfoot and see in low light.
- Back-buttering
- spreading mortar on the tile’s back as well as the bed, for full coverage under large formats.
- Coverage
- how completely mortar supports the tile; voids become cracks.
- Setting out
- deciding where the pattern starts and where cuts land, before the first tile.
- Movement joint
- a flexible joint that lets the building move without cracking the tile field.
- Flood test
- plugging and filling a shower pan to prove the waterproofing holds before tile goes on.
- Grout joint
- the filled line between tiles; its width is a design and precision decision.
- Threshold and transition
- where one floor meets another, planned as a detail rather than improvised.
The Deep Pages
- Slip ratings explained for the R-value story in full.
- Rectified tile explained for the edge story.
- Porcelain vs ceramic for the body story.
See the Tile at Full Scale
Bring room photographs, approximate measurements and any cabinet door, counter sample or finish that must stay. We will compare the relevant surfaces together in the South Scottsdale showroom and help narrow the choice before installation decisions are made.